Spalakh-M
Charge Initiation Device
SPALAKH-M is a multifunctional initiation device designed for the controlled detonation of a warhead through contact or non-contact munition initiation.
The built-in accelerometer rapidly detects collisions with hard and soft targets. The device supports configurable initiation modes and algorithms, commands received via PWM and UART, and operation using a self-destruct timer.
Device status and timer values can be displayed on an OSD when integrated with flight controllers running Betaflight or ArduPilot.
Spalakh-M is developed in accordance with the requirements of the Ministry of Defense of Ukraine
TU U 27.9-45948363-001:2025
NSN 5998-61-019-3947
Purpose
Quadcopter and fixed-wing UAVs
Long-range UAVs
Compatible with munitions
Initiation Types
1
Accelerometer-based initiation (hard / soft / mixed target)2
Initiation via dry contact (“whiskers”)3
Initiation via PWM signal4
Initiation via UART command5
Self-destruct timerTechnical Specifications
| Parameter | Value |
|---|---|
| Supply voltage | 3 V (CR123A, lithium) |
| Detonator voltage | 17–19 V |
| Battery life | at least 12 hours |
| Response time - via accelerometer (hard target) | up to 4 ms |
| Response time - via accelerometer (soft target) | up to 20 ms |
| Response time - via dry contact signal | <1 ms |
| Response time - after receiving PWM command | <1 ms |
| Response time - after receiving command via UART | <1 ms |
| Interfaces | USB Type-C, UART |
| Form factor | monoblock |
| Mounting | zip ties / double-sided tape / body integration |
| Dimensions | 34×24×60.5 mm |
| Weight | 60 g (with battery) |
| Body | protected, impact-resistant |
| External modules | none |
| Material | plastic |
Durability and Operational Indicators
| Parameter | Value |
|---|---|
| Operating temperature | -30°C to +50°C |
| Humidity | up to 98% at +20°C |
| Body protection rating | IP54 |
| Resistance | to sand and dust |
| Detection | does not unmask UAV (no sound signals) |
| Service life | 2 years |
| Storage with battery installed | 12 months |
| Storage without battery | 3 years |
| Use on one UAV | multiple devices possible |
| Maintenance | no periodic maintenance required |
Connection Interfaces
PWM and UART
for receiving commands from UAV
External sensors, LiDAR*
The possibility of connection must be confirmed with the manufacturer in advance
Betaflight, Ardupilot integration
Ability to display status and timer values on pilot's OSD
LED status indication
USB-C
for configuration
Convenient Configurator
Intuitive interface for configuring all device parameters
Available for Mobile/Tablet/Laptop/Website (Windows, macOS, Linux)
Activation and Safety
ON/OFF Button
Turns on/off the initiation board, autonomous operation after activation
Mechanical safety pin
Breaks the electrical circuit to the initiator
Armed delay timer
Time from powering on the initiation board to arming the system (2 - 45 minutes)
Self-diagnostics
Real-time initiation circuit self-test and error status can also be checked in the configurator